X10 PRO XPCR Signal Coupler Repeater Booster - Factory Fresh

Description

CLICK HERE FOR EASY, ONE STOP SHOPPING IN MY EBAY STORE: BIG JOHNS PLACE
X10 PRO XPCR SIGNAL COUPLER REPEATER BOOSTER
FOR SPLIT OR 3 PHASE ELECTRICAL SYSTEMS
240V OR 120/208V
Recommended in situations where the residence is over 3,000 square feet and/or the transformer "feeding" power to the house is over 100 feet away. Installs at the electrical panel to couple, amplify and repeat X10 command signals on split and 3-phase panels.
Nearly all residential homes are wired SPLIT-PHASE. Each 120V Phase is NOT directly connected with the other 120V phase. If after installation, an X10 Module does not respond to an X10 controller, check to ensure that the breaker serving the X10 Module is on the same phase as the Controller. If not, the breaker can be changed to the opposite phase.
An alternative solution is recommended, to install a Phase Coupler for
improving remote communications throughout the home.
The X10 PRO Phase Coupler/Repeater serves as a signal-bridge across Split-Phase and 3-Phase Power Systems. The XPCR accepts X10 Controller Commands from one phase (L1), regenerates the X10 Command to full signal strength and repeats it to the other phase (L2) and/or phases (L3). The XPCR performs this function in any directions, i.e. - (L1 to L2/L3 or L2 to L1/L3, or L3 to L1/L2).
The XPCR's Red LED indicator illuminates when an X10 Command is sent by an X10 Controller and repeated by the XPCR.
The XPCR is
NOT
a line noise filter or signal blocker. It is designed to couple and repeat X10 line signals from one phase to the other(s). In
most
cases, this is sufficient to overcome moderate line noise. When severe line noise or external signals are present, they must be located and treated using an appropriate
LINE NOISE FILTER OR SIGNAL BLOCKER
If you’re using an X10 wireless remote or motion sensor, you may be out of range of the transceiver. In these cases, an
SR751 RF SIGNAL REPEATER
, available in my Ebay store, may help.
Also read the description for our
X10
PLC01 POWERLINE CARRIER REPEATER
which may repeat and boost X10 line signals enough to overcome some phase and line noise issues.
Note:
Installation should be performed by knowledgeable installers only. The main breaker must be turned off during installation. The coupler must be installed in a suitable workbox or enclosure per local code. Installation must be in accordance with all applicable codes and requirements, including, but not limited to, the National Electrical Code (NEC).
Click here to see the Installation Manual
Retrieved from "
https://kbase.x10.com/wiki/XPCR
"
CLICK HERE TO SEE MORE X10 DEVICES
DON'T SEE WHAT YOU WANT? NEED LARGER QUANTITIES? Contact me with your zip code and email address with your requirements
IF YOU BUY ITEMS FROM MULTIPLE LISTINGS, DO NOT MAKE SEPARATE PAYMENTS. THIS CREATES SEPARATE SALES RECORDS AND INVOICES AND WILL DELAY PROCESSING AND SHIPMENT OF YOUR ORDERS . I CANNOT COMBINE ORDERS FOR SHIPPING DISCOUNTS (IF AVAILABLE) ONCE YOU MAKE ANY SEPARATE PAYMENTS
THANK YOU FOR LOOKING!!
IF YOU HAVE TROUBLE WITH SOME OF YOUR X10 MODULES AND DEVICES NOT WORKING CLICK HERE AND SEE IF A PHASE COUPLER/SIGNAL BRIDGE CAN HELP!
Check out my
other items
!
Be sure to add me to your
favorites list
!
Sign up for my email newsletters
by adding my eBay Store to your Favorites
Visit My eBay Store: Big John's Place