Complete Dynapath Cnc Control Package With Cabinet And Console

Description

Perfect unit to replace an old worn out Anilam control!
This sale is for a complete dynapath cnc control package removed from a knee mill. It will include the manual, 1000 line motor encoders, console, cabinet, D.C. power supply, servo amplifiers and everything else in the cabinet. It runs on 240v or 480v.
The Dynapath system works great and has been trouble free since I purchased the mill earlier this year. The power supply was replaced with a new Mean Well unit sometime before I bought the mill.
This machine came from a large, well known shop and appears to have been well maintained and seen very little use.
I removed this control from service due to a glitchy X axis servo amplifier. When power is supplied to the amplifiers, all 3 amps power up fine. After roughly 45 seconds, the X axis board would shut down and the (temp/RMS) l.e.d. would be illuminated. This began to happen on about 70% of machine start-up's.
I will include two extra servo amplifiers made by Westamp.
I took pictures and made notes of everything I had disconnected during removal which was kept to the bare minimum. I also tagged wires to provide the purchaser with an easier install. 3 pairs of db9 plugs will be included to provide you with a clean way to wire in the encoders.
This control powered (3) Baldor 28 in/lb motors which are not included with this sale.
The only components NOT included in this sale are motors and limit switches.
Local pick up only.