12V 15A dry contact 0v out momentary relay switch with 2 remote key fob RP11

Description

RP11 12V DRY CONTACT MOMENTARY RELAY SWITCH WITH 2 WATER RESISTANT REMOTE KEY FOBS
*Need a switch that you can just press and hold the remote button for momentary closing a contact?
*This kit momentarily
open or close contact
on your project remotely
*Press and hold any one of the button on the remote to close the contact, release the button to open the contact. when in standby, contact is stay at "open" position.
*Hook up your project between two white wires of this kit, and when remote is pressed, it will act as a momentary open/close switch.
*No 12V will be presented at the switching contact on this kit, if you also need 12V at the contact, please use our RM11 instead.
*Use this kit as a simple switch to momentary make contact open or close remotely. Prefect for any projects, home, automobile,boat, etc...
*Compact size with mounting holes make it easier for installation.
*Comes with 2 remote controls, 1 receiver box.
*This one channel kit had programmed with its unique code so there will be no interference, even if you have 2 or more kits operate side by side.
Specs:
Input voltage: requires 12V DC with minimum 500mA power source
(do not connect direct to any AC power, use an AC to DC adapter)
Standby current: 4.5mA
Remote response range: 50ft, range can be extended further depend in area, device setup and remote control battery strength…
Operating Bandwidth: 315MHZ
Remote
Battery
type: A27
Relay: 12~30VDC@15Amp, 110~250VAC@15Amp.
Receiver Box Dimension: 1 7/8" x 1 7/8" x 1" (4.7cm x 4.7cm x 2.5cm)
Momentary mode:  press and hold remote button to close contact, release remote button to open relay contact
Dry contact 0 volt output:  this kit does not supply any power to your application, it only act as an open or close contact switch